Comments on: 3 Symptoms of a Bad Speed Sensor (Engine or Vehicle Speed)

By: Sean

Sean — Sat, 03 Dec 2022 20:04:23 +0000

In reply to Tunji. I'm not sure I understand. What was the last work that was done to the car? Are there any codes?

By: Tunji

Tunji — Tue, 29 Nov 2022 20:21:39 +0000

Good evening mr Sean… I have a toyota matrix 2007…recently my mechanic just worked on the engine cause it got knocked… Now the engine works fine, but the issue now is, we try test driving, it is so slow in thinking to move, but when it moves, it goes on, it is hard to climb little height hill.. The speedometer is not moving also.. Please what could be the issue? Rewire tech tried to change the clip socket to the speedometer cus it got broken during mechanic work, which left the terminals with only the 3 pins connector. Please help, thanks, I don’t want the gear to be tampered with.. Cause rewire was saying I should see a gear master

By: Sean

Sean — Thu, 17 Nov 2022 15:22:48 +0000

In reply to Ashly Stoner. Do you know what that green light is supposed to mean? I would take the car back to the shop that replaced the transmission and have them take a look at it. They will likely stand behind their work.

By: Ashly Stoner

Ashly Stoner — Tue, 15 Nov 2022 00:33:35 +0000

I have a 2004 honda accord and recently had a check engine light come on. When I had it read, it showed 02 sensor. When I brought it to my mechanic, he told me it was the catalytic converter. Upon driving my car, the gears were slipping and my mechanic told me that I needed a new transmission. I got a used transmission put in. Drove the car for about a week, no problem!! Now, the car is having weird trouble shifting gears. It kind of goes into limp mode after reaching 3rd gear. I have to pull over, put car in park. Turn engine off and back on. I can usually tell when this is about to happen because the green light beside the D on the display panel will start to blink. Any thoughts on what this might be?!?? Maybe a sensor??

By: Sean

Sean — Thu, 08 Sep 2022 13:39:21 +0000

In reply to SAJEEV. It could be an issue with one of the control modules or something going on with the wiring, like a short from worn insulation. I think that will require a diagnosis at a mechanic's shop to solve the problem.

By: SAJEEV

SAJEEV — Wed, 07 Sep 2022 07:15:55 +0000

I have a 2010 Chevy Malibu,the car drives great for 10 to 15 miles and then goes into Limp-In mode and turns on the Check Engine light. At this point I can pull over and turn the car off, wait a few seconds, restart the car and drive away. It drives perfectly for another 5 to 10 miles and then goes back into Limp-In mode.I have a cheap code reader that tells me the only two error codes are P0601 (check sum error) and P0700 (trans issue)
Please let me know if you have had this problem and what was done to repair it.

By: Sean

Sean — Mon, 29 Aug 2022 17:44:30 +0000

In reply to Mujtaba. I'm not sure I understand. Is the car acting like it wants to stall?

By: Mujtaba

Mujtaba — Mon, 29 Aug 2022 13:33:14 +0000

Hi ,
I have toyota camry 2008 model , my car problem when i leave the gas padel RPM goes down and suddenly comes up even the car force also reduce and increase during the up down of RPM. i have changed Engine plugs, no have any sensor code on display , fuel injector also cleaned . but the problem still same can you suggest whati will do

By: Sean

Sean — Mon, 11 Apr 2022 16:13:04 +0000

In reply to Mohammed Nadeem Qureshi. Can you hear the truck attempting to go into gear?

By: Mohammed Nadeem Qureshi

Mohammed Nadeem Qureshi — Fri, 08 Apr 2022 20:43:29 +0000

I have Chevy Tahoe 2005. Engine works when shift the gear to drive vehicle doesn’t move what is the possible reason?