Comments on: P0335 Code (Symptoms, Causes, and How to Fix)

By: Sean

Sean — Mon, 18 Jul 2022 16:00:32 +0000

In reply to MQOLISI KHOZA. Are you absolutely sure those two crankshafts are compatible? When you replace a crankshaft, usually you have to do some machining and careful selection of rod bearings to make sure the clearances and tolerances are all correct. Did you perform this step?

By: MQOLISI KHOZA

MQOLISI KHOZA — Mon, 18 Jul 2022 10:07:32 +0000

I rebuilt my engine with a new crankshaft, replaced a 1.4 with a 1.6 crankshaft now the car is not revving mostly importantly it is no longer starting, bought a new crank position sensor still not working compared the number of teeth as well as the length of the two crankshafts every is the same only the stroke as well as the conrods differ, still no luck

By: Sean

Sean — Tue, 01 Jun 2021 21:46:47 +0000

In reply to jay. You may have to do some electrical diagnostics to determine if it's a wiring issue that's throwing the code, not the sensor itself.

By: jay

jay — Mon, 31 May 2021 11:20:24 +0000

my po335 light is not going off after repacing both sensors from agents Nissan almera
what must I do/

By: autotechnician

autotechnician — Thu, 21 Mar 2019 15:07:26 +0000

In reply to Hady.

Here are a couple videos that do a good job explaining:

By: Hady

Hady — Mon, 18 Mar 2019 17:28:05 +0000

How to test ckp sensors via multimeter and what is the normal value during reading thanks