Comments on: 7 Causes of a Car That Pulls to the Right or Left (When Braking)

By: Sean

Sean — Thu, 10 Nov 2022 19:23:42 +0000

In reply to Darrell. Check your suspension, suspension bushings, alignment, and tie rods. This is something you'll want a shop to look at. Many tire shops can do these types of inspections.

By: Darrell

Darrell — Thu, 10 Nov 2022 00:19:34 +0000

I have a dodge charger. when I brake or hit bumps car. Shift to the right. I kno I need breaks & rotors. So what can this be ???

By: Sean

Sean — Fri, 28 Oct 2022 03:46:05 +0000

In reply to Jim. How is the wear on the replacement brake pads? Does the wear pattern match from left to right? If one side is wearing more than the other, it could be a bad brake hose or master cylinder. Do you notice that it is easier to steer one direction than the other? If you can't find anything with the brakes, I might check the tie rods and suspension bushings next. Perhaps the wheel bearings as well.

By: Sean

Sean — Fri, 28 Oct 2022 03:37:33 +0000

In reply to Sandra. A lot of things could cause that. The alignment could be off, one caliper could be sticking, you could have a bad tie rod, or your suspension bushings could be worn out.

By: Jim

Jim — Wed, 26 Oct 2022 23:25:53 +0000

Mt 73 merceds sl 450 pulls to the right. I have replaced the pads , calipers, had to front and n alignment, and new tires. It still pulls only when I apply the brakes

By: Sandra

Sandra — Mon, 24 Oct 2022 19:17:42 +0000

I have a 1958 Mercedes and it pulls to the left when braking. I have already checked Tyre pressure. What can possibly cause it

By: Sean

Sean — Mon, 24 Oct 2022 14:49:36 +0000

In reply to Mike. That guess sounds like a good one to me.

By: Mike

Mike — Fri, 21 Oct 2022 09:34:38 +0000

My 1994 Nissan D21 pulls to the right when braking heavily. I’ve replaced front pads, rotors, calipers, hoses and master cylinder and it still does it. I can steer my tractor using its independent rear brakes and am wondering whether I have a poorly adjusted rear drum causing a similar effect.

By: Sean

Sean — Thu, 13 Oct 2022 14:13:41 +0000

In reply to Henry. Does the car swerve under braking or when cruising normally?

By: Henry

Henry — Tue, 11 Oct 2022 15:56:08 +0000

Hi I have a 07 Nissan 350z. No abs comes on. With the abs module connected, the brake squeaks when pressing and de-pressing stationary. At high speed, the car swerves. With the abs module disconnected, no sound when braking (park position) but car swerves at high speed. I happened before, I replaced the module. It worked fine for a few months then this happens again. Replaced with used part. What could be the cause?